Clip Frame Measurement Process

Overview

Clip frame measurement is used to measure fitting parameters for existing frames in a store, requiring the frame to be clipped onto the clip frame as centered as possible. Clip frame measurement is a feature provided by AMOS at no cost.

Preparation

• Enter Frame A Value: Obtain the A value from the frame's temples or lenses and enter it accurately (this affects measurement precision).
• Clip the Frame: Secure the frame onto the clip frame, ensuring it is as centered as possible (avoid excessive left-right offset).

Measurement Process

1. Initiate Measurement:
2. Click "Clip Frame Measurement" on the homepage and enter the A value to begin.
3. Take Three Photos:
4. First and Second Photos (Frontal): Requirements are the same as for measurement frame measurement; ensure the pose is level.
5. Third Photo (Right Side):
   • The clip frame side has 3 QR code points; ensure at least 2 are clearly visible.
   • The frame's side must not be obstructed by the clip frame.
6. Failure Handling: Same as for measurement frame measurement.
7. Calibration Points:
8. Frontal Frame:
   • Adjust the left and right calibration boxes so that all four edges align with the inner edges of the frame (must be the inner edges).
9. Side Pupil: Same as measurement frame measurement; align the right edge of the red circle with the right edge of the cornea.
10. Side Frame Tangent:
    • Adjust the red tangent line to align with the inner edge of the frame.
    • Use the blue dot to adjust the tilt angle to match the frame's side tilt.
11. Start Measurement:
12. Click "Start Measurement"; AI will process the data and redirect to the report page.
13. Failure handling is the same as for measurement frame measurement.

Notes

• Ensure the A value is accurate.
• Center the clip frame alignment, avoiding significant offsets.
• Strictly follow the interface prompts for shooting and calibration.

AI Helper

×